56 oz Unidoor Horizontal Liquid Soap Dispenser
Face Plate: Fabricated of #18 ga stainless steel with #4 satin finish, one
piece construction with 112• returns to wall. Wall housing is fabricated of
#22 ga pre-plated steel with 1/4" returns to wall for added rigidity. Soap
capacity viewer is integral part of face plate.
Tank: Molded, translucent Lexon tank, shatterproof and corrosion
resistant Large opening for easy servicing and covered sides prevent
Valve: (U001) Theft resistant chrome on brass all purpose bellows type
soap valve, with chrome on brass hex nut. Neoprene seals and a stainless
return spring will provide a pre-measured, drip free dispensing system.
Valve cannot be removed without taking hex nut off.
Lock: Pin tumbler, commercial quality type lock is keyed like all other AJW
Overall Size: 10"W x 6"H x 4 114"0
253mm x 152mm x 108mm
Wall Opening: 9 1/8'W x 5 1/16"H x 4"0
232mm x 129mm x 102mm
Capacity: 56 fl ounces
Coordinate installation with architect and contractor to avoid
interference with pipes vents etc. in wall. Remove face plate and install
wall housing into wall opening with proper fasteners per application.
Fill soap tank with proper soap and install into housing. Secure face
plate and prime valve for dispensing soap.
Soaps: All purpose low viscosity lotions and liquid synthetic detergents
or oils, and vegetable based soaps should be used.
Preventative Maintenance: Each dispenser should be cleaned out
aprx every 30 days with warm water to prevent sludge build up from
clogging valve. Do not use abrasive cleaners when cleaning dispenser.
•*For best performance, use pre-mixed low concentrate solutions.
Dispensers should have periodic maintenance performed to insure
the life dispenser. Rinse out globe and valve with warm water to avoid