High Speed Automatic 120 Volt Hand Dryer - Surface Mounted
Motor: Brush type, dual ball bearings, 12000 - 18000 RPM (adjustable),
15/16 HP thermally protected against overheating and is auto resetting.
Available in 120 or 230V with 50 I 60 HZ
Heater Element: 450 - 900 watt (adjustable) Air output temperature is 113
degrees F at nozzle with an ambient temperature of 68 degrees F. Dryer
shall deliver 51-68 CFM
Drying: 15 second drying time in optimum conditions. Timing protection
feature of 60 seconds will automatically tum off and not restart until the
sensor reset's itself.
Sensor: Hands free operation with adjustable sensor range 2" - 13".
Standard range is 7".
Cover: High gloss white painted steel cover secured to base with theft
resistant fasteners.
Overall Size: 8 5/64'W x 11 19/64"H x 7 6/64"0
(205mm x 287mm x 180mm)
U1512EA-SF: Same as U1512EA with satin finish, stainless steel cover.
Unit Volts Amps Cycles
U1512EA-120V 110-120 14 50/60
U1512EA-230V 208-230 7 50/60
U1512EA-120V
Installation
Coordinate installation with architect and contractor to avoid
interference with pipes, vents, etc in wall. Insure the service for the
hand dryer is correct for the dryer being installed. The dryer must be
installed by a licensed electrical contractor to honor warranty Place
template on wall surface and transfer all mounting point locations.
Check all codes for proper mounting heights for each application. All
mounting heights must be based on a finished floor to eye sensor
location dimension. Secure base to wall surface with proper anchors.
(Anchoring devices not supplied) Properly connect power supply to
dryer and test operation before securing cover. After dryer checks
good secure cover with theft resistant fasteners supplied Test dryer
again for proper operation. Recommend one dryer for every two
basins.