Lever Operated, Roll Towel Dispenser - Surface Mounted
Cabinet Body: Fabricated of #22 ga stainless steel with #4 satin finish.
Cabinet Door: Fabricated of #18 ga stainless steel, #4 satin finish. Lever
opening has been deburred to prevent injury and allow a smooth lever
Back: #22 ga stainless steel, with key holes slots for mounting.
Roll Towel Mechanism: Operable with one hand and less than 5 bs of
force without any turning of wrist or tight grasping. Adjustments can be
made to dispense three pre-set amount of paper to be dispensed per
stroke. Unit is equipped with an automatic stub roll transfer.
Lock: Pin tumbler, commercial quality lock, keyed Ike all other AJW
Hinge: Full length , heavy duty, stain less steel
Overall Size: 12 1/4'W x 16'H x 10 1/2'D
311mm x 406mm x 267mm
Capacity: One standard size roll of 8' or 9" wide. (Use only non-perforated
towels). One stub roll up to 2 314" OD
*Recommended 600ft roll for best results.
Provide an area on mounting surface at desired or specified location.
Coordinate installation with architect I contractor. Open cabinet door,
place unit against wall making sure unit is level and transfer mounting
points. Top of cabinet should be no higher than 48" above finished floor
to comply with ADA Code. Secure cabinet to wall surface with proper
fasteners for each application. Load towels in cabinet per instruction