Automatic, Roll Towel Dispenser - Surface Mounted


Cabinet Body: Fabricated of #22 ga stainless steel with #4 satin finish.
Cabinet Door: Fabricated of #18 ga stainless steel, #4 satin finish.
Back: #22 ga stainless steel, with key hole slots for mounting.
Roll Towel Mechanism: Internal mechanism is fabricated of high impact
plastic operated by an automatic sensor.
Sensor: Operated by four (4) D cell batteries (not included). After batteries
and paper have been property installed, pass hands through sensor range
to activate motor. After unit has 30 seconds to cal brate, it is ready to
dispense. It takes aprx. 6 dispenses to adjust to the proper paper length.
After the sensor range has been interrupted, paper will not be dispensed
until sensor range has been cleared to reset.
Lock: Pin tumbler, commercial quality lock, keyed Ike all other AJW
Overall Size: 12 1/4'W x 16"H x 9"D
311mm x 406mm x 228mm
Capacity: One standard size roll of s• or 9" wide. (Use only non-perforated
towels). One stub roll up to 2 314" OD
*Recommended 600ft roll for best results.



Provide an area on mounting surface at desired or specified location.
Coordinate installation with architect I contractor. Open cabinet door,
place unit against wall making sure unit is level and transfer mounting
points. Top of cabinet should be no higher than 48" above finished floor
to comply with ADA Code. Secure cabinet to wall surface with proper
fasteners for each application. Load towels in cabinet per instruction

Mailing Address​

1375 Eber Street

San Diego, CA 92107-3812


T: 619-501-9602

Fax: 619-501-9603


QNS Distributors has been servicing the needs of commercial and industrial accounts since 1971. We offer a full line of production and warehousing products by industry leaders, Akro-Mils and Molded Fiber Glass Tray Company. 

Whether your needs are large or small, QNS Distributors can handle any order!

© Elias Consultancy 2020