Body: Fabricated of#22 ga stainless steel with a #4 satin finish.
Flange: Fabricated of #22 ga stainless steel, satin finish with no miters or
welds and 1 /4" returns.
Uni-Door: Fabricated of #18 ga stainless steel, #4 satin finish with 1/2"
returns and full length door stops.
Back: stainless steel formed for rigidity with multiple welds to cabinet body.
Automatic Dispenser: Operated by 4 "D" cell alkaline batteries (not
included) that will dispense one standard roll 8"wide with a maximum 7
3/4" OD. Automatic sensor will dispense a re-measured amounts of paper
each time and will not dispense paper again until sensor range is cleared
and allowed to reset itself.
Removable Waste: Removable steel waste.
Hinge: Full length, stainless steel piano type hinge.
Locks: Commercial quality, pin tumbler keyed alike.
Collars: 304 #22 ga stainless steel matches cabinet finish.
Overall Size: 14 5/8'W x 54 1/4"H x 10"D
371mm x 1378mm x 254mm
Wall Opening: 12 3/4"W x 52"H x 9 3/4"D
324mm x 1334mm x 248mm
Towel Capacity: One standard roll up to 8" wide (non-perforated)
Waste Capacity: 11.25 gallons (1.5 cu ft)
*Recommended 600ft roll for best results.
U6104EA-S2: Semi-recessed 2" collar with 6" wall opening
U6104EA-S4: Semi-recessed 4" collar with 6" wall opening
U6104EA-S6: Semi-recessed 6" collar with 4" wall opening
U6104EA-SM: Surface mounted
-VL 1: Reusable vinyl liner



Coordinate installation with contractor and architect to avoid
interference with pipes vents etc. Provide a rough wall opening 12
3/4"W x 52 1/2"H. Wall opening depth will depend on style mounting
lf a collar is required, slip over back of unit. Remove waste & install
unit in opening. Make sure cabinet will sit flush in wall and secure with
proper fasteners per application. Install waste back into cabinet, install
batteries and load paper towels.
When cleaning cabinet, use a soft cloth, a non-abrasive or chloric