Automatic Roll Towel Dispenser & Waste Receptacle Combination w/ Extended Waste - Recessed


Body: Fabricated of #22 ga stain less steel with a #4 satin finish.
Flange: Fabricated of #22 ga stainless steel finished to match cabinet with
1 /4" returns. (No miters or welds)
Cabinet Back: Fabricated of stainless steel formed for rigidity.
Cabinet Door: Fabricated of #18 ga stainless steel with #4 satin finish,
with full length door stop to reduce vandalism
Towel Mechanism: Internal mechanism is fabricated of high impact plastic
operated by an automatic sensor.
Automatic Sensor: Operated by 4 "D" cell batteries (not included} Takes
aprx. 6 cycles to calibrate after batteries installed. After sensor range has
been interrupted, paper will not dispense until range is cleared to reset
Removable Extended Waste: Fabricated of #22 ga stainless steel #4
satin finish with all leading edges to have a radius.
Hinge: Full length , heavy duty, stain less steel piano type hinge.
Collars: Type 304#22 ga stainless steel, #4 satin
Overall Size: 14 1/4'W x 54"H x 10"0
362mm x 1372mm x 254mm
Wall Opening: 12 3/4"W x 52 1/2"H x 4"0
324mm x 1334mm x 102mm
U659EA-S2: 2" semi-recessed. collar, 2" wall opening, 51 mm
U659EA-SM: Full surface mounted collar.
Waste Capacity: 12 gallons (1.60 cu ft)
Towel Capacity: One standard size roll of 8" or 9" wide. (Use only nonperforated
towels}. One stub roll up to 2 3/4" OD
*Recommended 600ft roll for best results.
-VL 1: Reusable vinyl liner



Coordinate installation with architect and contractor to avoid
interference with pipes, vents, etc. Provide a rough wall opening 12
3/4"W x 52 1/2"H. Required wall depth, will depend if full or semirecessing
is required. If collar is required, slide collar over the back
before installing into wall. Remove waste from cabinet and mount unit
plumb and true in opening with proper fasteners per application Load
batteries and towels and secure waste in cabinet Test unit for proper
Controls and or mechanisms should operate with one hand and force
required to activate controls shall be no greater than 5 lbs. (427.4)

Mailing Address​

1375 Eber Street

San Diego, CA 92107-3812


T: 619-501-9602

Fax: 619-501-9603


QNS Distributors has been servicing the needs of commercial and industrial accounts since 1971. We offer a full line of production and warehousing products by industry leaders, Akro-Mils and Molded Fiber Glass Tray Company. 

Whether your needs are large or small, QNS Distributors can handle any order!

© Elias Consultancy 2020