Body: Fabricated of #22 ga stain less steel with a #4 satin finish.
Flange: Fabricated of #22 ga stainless steel finished to match cabinet with
1 /4" returns. (No miters or welds)
Cabinet Back: Fabricated of stainless steel formed for rigidity with multiple
welds to cabinet body.
Cabinet Door: Fabricated of #18 ga stainless steel with #4 satin finish,
with full length door stop to reduce vandalism
Towel Dispenser: Hands free roll mechanism is fabricated of #20 ga steel
fonned for rigidity. Unit will accommodate one 8" or 9" wide roll with a max
0.0. of 7 7/8". Manual side rotating knob allows maintenance crew to start
roll. When paper is tom a starter piece will be partially exposed.
Removable Extended Waste: Fabricated of #22 ga stainless steel #4
satin finish with all leading edges to have a radius. Unit is secured in place
by a bottom bracket guide and top lock. Embossed tabs allow liners to be
held in place.
Hinge: Full length, heavy duty, stainless steel piano-type hinge.
Collars: Fabricated of #22 ga stainless steel, #4 satin finish.
Locks: Pin tumbler type, keyed like all other AJW cabinets.
Overall Size: 14 1/4'W x 54"H x 10"0
362mm x 1372mm x 254mm
Wall Opening: 12 3/4"W x 52 1/2"H x 4"0
324mm x 1334mm x 102mm
U659HF-S2: 2" Semi recessing collar
U659HF-SM: Full surface mounted collar
Waste Capacity: 12 gallons (1.60 cu ft)
Towel Capacity: One standard size roll of 8" or 9" wide. (Use only nonperforated
towels). One stub roll up to 2 3/4" OD
*Recommended 600ft roll for best results.
-VL 1: Reusable vinyl liner



Coordinate installation with architect and contractor to avoid
interference with pipes, vents, etc. Provide a rough wall opening 12
3/4"W x 52 1/2"H. Required wall depth, will depend if full or semirecessing
is required. If collar is required, slide collar over the back
before installing into wall. Remove waste from cabinet and mount
unit plumb and true in opening with proper fasteners per application.
Secure waste in cabinet and load paper towels.
Controls and or mechanisms should operate with one hand and force
required to activate controls shall be no greater than 5 lbs. (427.4)