16"W x 30"H Angle Frame Mirror - Plate Glass Surface


Frame: Fabricated of #18 ga stainless steel, #4 satin finish. 3/4" x 3/4"
frame with welded mitered comers are ground and polished smooth. #22
ga concealed 'Z' channel is spot welded to inner perimeter of frame for
reinforcement and greater rigidity.
Mirror: 1/4" thick type 1 transparent flat type, class 1 - clear glass mirrors.
Mirror is coated with silver and sealed with a uniform electrolytic copper
plating, along with two coats of paint for added protection. Mirrors are
guaranteed against silver spoilage for a period of 15 years. Mirrors
conform toASTM C1036 andASTM C1503-R8.
Filler: 3/16" thick full size, shock absorbing, water resistant, non-abrasive
polyethylene padding protects all concealed mirror surfaces.
Back: #20 ga pre-plated galvanized steel, with embossed horizontal louver
mounting brackets. Embossed theft resistant pressure activated clip lock
device, locks mirror in place to wall hangers. Back is secured to frame with
concealed Phill ips head screws.
Hangers: Fabricated of #20 ga pre-plated steel galvanized steel with
mounting points.
Standard Sizes Available (W x H): 16"x24", 16"x20", 16"x30", 18"x24"
18"x30", 18"x36", 20"x60", 24"x30" 24"x36", 24"x42", 24"x48", 18"x60",
24"x60", 24"x72", 18"x72"
LG: Laminated Glass
LX: Polycarbonate
PM: Plastic Acrylic
T: Tempered Glass
VC: Vinyl Clad (Safety Glass)
88: #8 Reflective Stainless Steel
•Stainless steel mirrors reflect images in different optic Quality than plate glass. There will
be a slight distortion Which increases proportionately with the mirror size. Therefore,
AJW Archttectural Products "cannot be held responsible for Quality of image.
•• Mirrors are always ordered Width x Height
.. ,.. Recommended max size for SB mirrors 72" x 47-112"
.... Framed mirrors are fabricated to a tolerance of(+/-) 118"
..... Mirrors conform to Federal Specifications OO-M-00411b & OOg- 5410.



Coordinate installation with architect I contractor for specific mounting
location and height for each mirror application. Making sure "I" bracket
is level, transfer all mounting point locations to wall surface from
drawing. Secure brackets with proper fasteners for each application.
Slide mirror down over horizontal brackets until clip lock secures mirror
in place. Mirror can only be removed by inserting tool through hole at
bottom of frame depressing clip This will allow mirror to slide up over
brackets. Fillers are available if mirrors are mounted above and below
tile line. (U004 Filler) filler material will match mirror frame to form a
one piece construction.
To meet ADA Code, bottom edge of reflective surface can be no higher
than 40" above finished floor. (4 19 6) Full length mirrors may be used
for universal application when installed in correct locations.
Abrasive cleaners & chloric solutions should not be used on mirrors.
Discoloring and /or scratching of frame and reflective surface may