Frame: Fabricated of #20 ga stainless steel, #4 satin fin ish. 1/2" x 1/2" X
1/2" frame with mitered corners. Frame is secured at one corner with a
stainless steel rivet.
Mirror: 1/4" thick type 1 transparent flat type, class 1 - clear glass mirrors.
Mirror is coated with silver and sealed with a uniform electrolytic copper
plating, along with two coats of paint for added protection. Mirrors are
guaranteed against silver spoilage for a period of 15 years. Mirrors
conform toASTM C1036 andASTM C1503-R8.
Filler: 1/8" thick full size, shock absorbing, water resistant, non-abrasive
polyethylene padding protects all concealed mirror surfaces
Hinge: Full length stainless steel piano type hinge mounted on the bottom
of the frame.
Back: #20 ga pre-plated galvanized steel.
Adjustable Arms: mirror can be used as a flush mirror or tilt forward up to
7" from wall surface for handicapped application.
Standard Sizes Available (W x H): 16"x24", 16"x30", 18"x24", 18"x30",
18"x36", 24"x30", 24"x36"
LG: Laminated Glass
LX: Polycarbonate
PM: Plastic Acrylic
T: Tempered Glass
VC: Vinyl Clad (Safety Glass)
88: #8 Reflective Stainless Steel
•stainless steel mirrors reflect images in different optic Quality than plate glass. There will be
a slight distortion Which increases proportionately with the mirror size. Therefore, AJW
ArcMectural Products - cannot be held responsible for Quality of image.
•• Mirrors are always ordered Width x Height
.. ,.. Recommended max size for SB mirrors 72" x 47-112"
··-Framed mirrors are fabricated to a tolerance of(+/-) 118"
··-·Mirrors conform to Federal Specifications OO-M-00411b & 00-<1-5410.



Coordinate installation with architect I contractor for specific mounting
location and height for each mirror application. Check all state an
local codes for installation requirements. Transfer mounting points to
wall surface for bottom hinge. Drill pilot holes to secure frame to wall
with proper fasteners. Hold mirror up and transfer adjustable e bow
mounting points to wall. Secure with proper fasteners and adjust
elbows to proper extended distance per application. To meet ADA code
mirrors bottom reflective edge must be at a height of 40" above the
finished floor. Full length mirrors may be used for universal application
when installed in correct locations.
Abrasive cleaners & chloric solutions should not be used on mirrors.
Dis-coloring or scratching may occur on frame and reflective surface.
•••ATTENTION • • •
It is the installer's respons bility to make sure the adjustable anm
mechanisms are anchored properly and securely, depending on type
wall conditions, being that they are the only means of top support. The
manufacturer will not be liable or responsible for damages or personal
injury due to improper installation.

Mailing Address​

1375 Eber Street

San Diego, CA 92107-3812


T: 619-501-9602

Fax: 619-501-9603


QNS Distributors has been servicing the needs of commercial and industrial accounts since 1971. We offer a full line of production and warehousing products by industry leaders, Akro-Mils and Molded Fiber Glass Tray Company. 

Whether your needs are large or small, QNS Distributors can handle any order!

© Elias Consultancy 2020