16"W x 30"H Fixed Tilt Angle Frame Mirror - Plate Glass Surface


Frame: Fabricated of #18 ga stainless steel, #4 satin fin ish. Stainless
steel frame is fabricated with welded mitered corners that are ground and
polished smooth. Mirror extends out 4• at top and tapers to 1• at bottom.
Mirror: 1/4" thick type 1 transparent flat type, class 1 - clear glass mirrors.
Mirror is coated with silver and sealed with a uniform electrolytic copper
plating, along with two coats of paint for added protection. Mirrors are
guaranteed against silver spoilage for a period of 15 years. Mirrors
conform toASTM C1036 andASTM C1503-R8.
Filler: 3116" thick full size, shock absorbing, water resistant, non-abrasive
polyethylene padding protects all concealed mirror surfaces
Brackets: Mounting brackets are fabricated of #20 ga pre-plated,
galvanized steel. Lower bracket has two (2) side mounting points that allow
frame to be secured to bracket.
Standard Sizes Available (W x H): 16"x24", 16"x30", 18"x24", 18"x30",
18"x36", 24"x30", 24"x36"
LG: Laminated Glass
UC: Polycarbonate
PM: Plastic Acrylic
T: Tempered Glass
VC: Vinyl Clad (Safety Glass)
SB: #8 Reflective Stainless Steel
•Stainless steel mirrors reflect images in different optic qual~y than plate glass. There will
be a slight distortion which increases proportionately with the mirror size. Therefore, AJW
Architectural Prod u cts~ cannot be held responsible for qualfy of image .
.. Mirrors are always ordered Width x Height
... Recommended max size for 88 mirrors 72" x 47-112"
.... Framed mirrors are fabricated t o a tolerance of(+/-) 1/8"
..... Mirrors conform to Federal Specifications DD-M-00411b & DD-g-5410



Coordinate installation with architect I contractor for specific mounting
location and height for each mirror application. Check all state an local
codes for installation requirements. Remove hanger brackets and
transfer mounting points to wall surface. Secure with proper fasteners
for each application. Slide mirror frame over brackets and secure
in place. Secure frame to bracket. Fillers are available if mirrors are
mounted above and below tile line. (U004 Filler) Filler material will
match mirror frame to form a one piece construction.
To meet ADA Code, bottom edge of reflective surface can be no higher
than 40" above finished floor. (4 19 6) Full length mirrors may be used
for universal application when installed in correct locations.
Abrasive cleaners & chloric solutions should not be used on mirrors.
Discoloring or scratching may occur on frame and reflective surface.

Mailing Address​

1375 Eber Street

San Diego, CA 92107-3812


T: 619-501-9602

Fax: 619-501-9603


QNS Distributors has been servicing the needs of commercial and industrial accounts since 1971. We offer a full line of production and warehousing products by industry leaders, Akro-Mils and Molded Fiber Glass Tray Company. 

Whether your needs are large or small, QNS Distributors can handle any order!

© Elias Consultancy 2020