Frame: Fabricated of #20 ga stainless steel, #4 satin finish. Roll formed
112" x 112" x 112" channel frame has mitered corners and secured with
stainless steel rivet.
Mirror: 1/4" thick type 1 transparent flat type, class 1 - clear glass mirrors.
Mirror is coated with silver and sealed with a uniform electrolytic copper
plating, along with two coats of paint for added protection. Mirrors are
guaranteed against silver spoilage for a period of 15 years. Mirrors
conform toASTM C1036 andASTM C1503-R8.
Filler: Full size, 1/8" shock absorbing, water resistant, nonabrasive,
polyethylene padding protects all concealed mirror surfaces.
Back: #20 ga pre-plated galvanized steel, with embossed horizontal louver
mounting brackets. Embossed theft resistant pressure activated clip lock
device, locks mirror in place to wall hangers.
Hangers: Fabricated of #20 ga pre-plated steel galvanized steel with
mounting points.
Standard Sizes Available (W x H): 16"x20", 16"x24", 16"x30",
18"x24", 18"x30", 18"x36", 24"x30", 24"x36", 24"x42", 24"x48", 18"x60",
20"x60", 24"x60", 18"x72", 24"x72"
LG: Laminated Glass
LX: Polycarbonate
PM: Plastic Acrylic
T: Tempered Glass
VC: Vinyl Clad (Safety Glass)
SB: #8 Reflective Stainless Steel
•Stainless steel mirrors renect images in different optic quality than plate glass. There will be
a slight distortion Which increases proportionately with the mirror size. Therefore, AJW
Arch~ectural Products - cannot be held responsible for quality of image .
.. Mirrors are always ordered Width x Height

0 Recommended max size for 88 mirrors 72" x 47 -1 /2"
.... Framed mirrors are fabricated to a tolerance of(+/-) 1/8"
..... Mirrors conform to Federal Specifications OO.M.00411b & 00-<1-5410



Coordinate installation with architect I contractor for specific mounting
location and height for each mirror application. Making sure "I" bracket
is level, transfer all mounting point locations to wall surface from
drawing. Secure brackets with proper fasteners for each application.
Slide mirror down over horizontal brackets until clip lock secures mirror
in place. Mirror can only be removed by inserting tool through hole at
bottom of frame depressing clip This will allow mirror to slide up over
brackets. Fillers are available if mirrors are mounted above and below
tile line. (U004 Filler) filler material will match mirror frame to form a
one piece construction.
To meet ADA Code, bottom edge of reflective surface can be no higher
than 40" above finished floor. (4 19 6) Full length mirrors may be used
for universal application when installed in correct locations.
Abrasive cleaners & chloric solutions should not be used on mirrors.
Discoloring and /or scratching of frame and reflective surface may