Dual Hooded Toilet Tissue Dispenser w/Auto Reserve - Recessed - Non-Controlled
Body: Fabricated of #22 ga stainless steel with #4 satin finish. Concealed
inner dispensing mechanism is #18 ga stainless steel.
Back: Fabricated of #18 ga stainless steel with multiple welds to cabinet
body forming a one piece construction.
Hood: Fabricated of #18 ga stainless steel finished to match cabinet body.
Hood is secured with stainless steel hinge rivets to cabinet body. Top roll of
tissue will not drop down unless the bottom roll has been depleted. When
unit is closed, this will provide a theft resistant, non-control operation and
reduce vandalism.
Flange: One piece construction without miters or welds fabricated of #22
ga stainless steel, with#4 satin finish to match cabinet.
Locks: Pin tumbler, commercial quality locks keyed like all other AJW
cabinets.
Spindles: (U005) Fabricated of one-piece molded high impact black ABS
material.
Overall Size: 8'W x 14"H x 6 3/4"0
203mm x 356mm x 171mm
Wall Opening: 6 3/8'W x 12 3/8"H x 3 5/8"0
162mm x 314mm x 93mm
Capacity: Two standard rolls with a 5 1/4" (133mm) OD.
U841
Installation
Coordinate installation with architect or contractor to avoid pipes,
vents, etc. Provide a rough wall opening in mounting surface at desired
or specified location. Open cabinet, remove spindles and insert into
opening. Secure unit with proper fasteners per each application Load
toilet tissue on rollers, place in concealed track and close hood. Raise
lower roll against upper and take hand away. Lower roll should fall
into place with upper roll remaining up above the hood line. If loaded
properly, top roll will not fall for use until bottom roll has been depleted.
When servicing dispenser, full rolls must be used on both spindles to
insure proper operation
To meet ADA code, dispensers cannot have any type of control
delivery (4 16)