Dual Stall Hooded Toilet Tissue Dispenser w/Auto Reserve - Parition Mounted - Non-Controlled
Body: Fabricated of #22 ga stain less steel with #4 satin finish. Concealed
inner dispensing mechanism is #18 ga stainless steel.
Back: Fabricated of #18 ga stainless steel with multiple welds to cabinet
body forming a one piece construction.
Hoods: Fabricated of #18 ga stainless steel finished to match cabinet
body. Hood is secured with stainless steel hinge rivets to cabinet body. Top
roll of tissue will not drop down unless the bottom roll has been depleted.
When unit is dosed, this will provide a theft resistant, non-control operation
and reduce vandalism.
Flanges: One piece construction without miters or welds fabricated of
#22 ga stainless steel,#4 satin finish. Adjustable to fit 3/4" - 1 114" thick
Locks: Pin tumbler, commercial quality locks keyed like all other AJW
Spindles: (U005) Fabricated of one-piece molded high impact black ABS
Overall Size: 14 1/4'W x 14' H x 9 7/8'D
362mm x 356mm x 251mm
Wall Opening: 121/2'Wx12 1/4'H
318mm x 311mm
Capacity: Four standard rolls with a 51/4" (133mm) OD.
Coordinate installation with architect or contractor. Provide a rough
wall opening in mounting surface at desired or specified location
making sure unit will be level. Open cabinet, remove spindles and
adjustable flange. Insert into opening and secure unit with proper
fasteners per each application. Secure adjustable flange with proper
fasteners. Load toilet tissue on rollers, place in concealed track and
close hood. Raise lower roll against upper and take hand away. Lower
roll should fall into place with upper roll remaining up above the hood
line. If loaded properly, top roll will not fall for use until bottom roll has
been depleted Follow same procedure for both sides. When servicing
dispenser, full rolls must be used on both spindles to insure proper
Toilet Paper Dispensers: All dispensers that are to meet ADA code
cannot have any type of controlled delivery. (416)