Retractable ADA Compliant Stainless Steel Shower Bench - Surface Mounted
Seat: Fabricated of#18 gauge #4 satin finish stainless steel welded to
frame. All leading edges on slats have a radius edge for safety.
Tubing: Fabricated of#18 gauge stainless steel with a #4 satin finish.
Main Frame: 1 1/4" square tubing with capped ends. Underside has no
Flanges: #18 gauge stainless steel with four (4) exposed mounting points.
Under slung supports have a 1 1/4" OD.
Leg Support: #18 gauge stainless steel one piece construction.
Mounting Bracket: #16 gauge stainless steel "hat" style bracket with four
(4) mounting points. Bracket acts as a guide to raise and lower platform.
For maximum support bracket should be mounted on finished floor to
accept load transfer. Seat will remain in an upright position when not in use
by means of a spring clip.
Overall Size: 32"W x 13 1/2"0 (seating area)
813mm x 343mm
To comply with ADA code, seat should be mounted at a height where
the seating location should be at a height of 17" - 19" above finished
floor. Check all State and Local code for building requirements.
Recommend in wall mounting on all shower seats (BP10) for maximum
strength. Place seat up against wall surface making sure seat is at the
proper mounting height level. Transfer all mounting point locations and
drill pilot holes. Secure seat with proper fasteners for each application.
(Fasteners not provided, must be ordered separate) Snugly secure
seat and check seat to be level and the raising and lowering of the
seat does not bind. When all checks good, finish securing fasteners.
When property mounted seat will support over 1300 lbs. To conform
with ADA code 4.21.3 and 4.26.3
Note: This shower seat is not intended to be installed in applications
that have shower bases with rounded comers. AJW recommends the
U928 for such applications.