Seat: Fabricated of 3/4" thick, one piece polymers (white) with all leading
edges having a radius to prevent injury. Seat is secured to frame with
carriage bolts and is reversible in field. (Handing not required) Seat is 1
1/2" off finished wall.
Tubing: #18 gauge stainless steel with a #4 satin finish.
Main Frame: #18 ga stainless steel square tubing with capped ends
Flanges: #18 ga stainless steel with four (4) exposed mounting points.
Legs: #18 ga stainless steel with adjustable non slip feet.
Guide Ann: Stainless steel that ensures full extension of support legs
when in use and as a guide to raise legs when retracting.
Overall Size: 32"1/1/ x 20 3/4"0 (seating area)
813mm x 527mm
U928R
Installation
To comply with ADA code, seat should be mounted at a height where
the seating location should be at a height of 17" - 19" above finished
floor. Check all State and Local code for building requirements.
Recommend in wall mounting on all shower seats (BP10) for maximum
strength. Place seat up against wall surface making sure seat is at the
proper mounting height level. Transfer all mounting point locations and
drill pilot holes. Secure seat with proper fasteners for each application.
(Fasteners not provided, must be ordered separate) Snugly secure
seat and check seat to be level and the raising and lowering of the
seat does not bind. When all checks good, finish securing fasteners.
When property mounted seat will support over 500 lbs. To conform with
ADA code 4.21.3 and 4.26.3