Seat: Fabricated of 3/4" thick, one piece polymers (white) with all leading
edges having a radius to prevent injury. Seat is secured to frame with
carriage bolts and acorn nuts. Seat is reversible and handing is not
required
Tubing: Fabricated of #18 ga stainless steel with #4 satin finish.
Main Frame: 1 1/4" diameter square tubing with capped ends.
Flanges: #18 gauge stainless steel with exposed mounting points. Under
slung supports have a 1114" OD
Supports: #18 ga stainless steel 1 1/4" dia diagonal stainless steel
support guides for raising and lowering of seat.
Mounting Bracket: #18 gauge stainless steel "hat" style bracket with four
(4) mounting points. Bracket acts as a guide for raising and lowering of
seat. For maximum support, bracket is mounted resting on floor absorbing
load transfer. Seat will remain in an upright position when not in use by
means of a spring clip. Seat has been tested to maintain a 500 b static
load.
Overall Size: 32"1/1/ x 20 3/4"'0 (seating area)
813mm x 514mm
'Wall to floor mounting design provides equal distribution of weight
to ensure safe operation.

U929L

$267.90Price

To comply with ADA Code, seat should be mounted at a height
between 17" - 19" above finished floor. Check all state and local
codes for building requirements .. Recommend in wall mounting on
all shower seats. (BP10) Place seat up against wall making sure the
extended part of seat has an offset no more than 1 112· away from
wall. (Same as grab bar) Transfer mounting points to wall surface
and drill pilot holes. Secure seat to surface with proper fasteners for
each application. Snugly secure seat to surface and check seat to be
level. If seat is level raise and lower seat to check path of travel. Finish
securing seat after checking seat for proper operation. When properly
mounted seat will support up to 500 lbs and will conform with ADA
Code 4.21.3 and 4.26.3, To change handing, remove carriage bolts,
switch square length tubing to opposite side and flip deck to change
handing and secure with carriage bolts to framing.
Note: This shower seat is not intended to be installed in applications
that have shower bases with rounded comers. AJW recommends the
U928 for such applications.

Mailing Address​

1375 Eber Street

San Diego, CA 92107-3812

CONTACT US

T: 619-501-9602

Fax: 619-501-9603

JOIN OUR MAILING LIST

QNS Distributors has been servicing the needs of commercial and industrial accounts since 1971. We offer a full line of production and warehousing products by industry leaders, Akro-Mils and Molded Fiber Glass Tray Company. 

Whether your needs are large or small, QNS Distributors can handle any order!

© Elias Consultancy 2020