Seat: Fabricated of 2 1/2" thick, water-resistant reinforced vinyl fabric
cushion (white) seamless design with all leading edges having a radius.
Seat is secured to a 112• thick marine plywood.
Tubing: Fabricated of #11 ga stainless steel with #4 satin finish.
Main Frame: #18 ga 1 1/4" with satin finish tubing. Underside has no
Flanges: #11 gauge stainless steel with four (4) exposed mounting points.
Under slung supports have a 1 1/4" OD. (Satin finish)
Mounting Bracket: #16 ga stainless steel ''hat" style bracket with 4
mounting support points. Bracket acts as a guide to raise and lower seat
platform and is equipped with four (4) points to secure to wall surface. For
maximum support, bracket is mounted so the bottom is set on the finished
floor surface. Seat will remain in an upright position when not in use by
means of a spring clip.
Overall Size: 32"1/1/ x 22"0 (seating area)
813mm x 559mm
U933L: Left Handed
U933R: Right Handed
To comply with ADA Code, seat should be mounted at a height
17" - 19" above finished floor. Check all state and local codes for
proper mounting requirements. Recommend in wall mounting on all
shower seats. (BP10) Place seat up against wall making sure the
extended part of seat has an offset no more than 1 112· away from
wall. (Same as grab bar) Transfer mounting points to wall surface
and drill pilot holes. Secure seat to surface with proper fasteners per
each application. Snugly secure seat to surface and check seat to be
level. If seat is level raise and lower seat to check path of travel. Finish
securing seat after checking seat for proper operation. When properly
mounted seat will support up to 250 lbs and will conform with ADA
Code 4.21.3 and 4.26.3
Note: This shower seat is not intended to be installed in applications
that have shower bases with rounded comers. AJW recommends the
U928 for such applications.