Tubing: Fabricated of #18 ga stainless steel with a #4 satin finish.
Available in 1 1/4" outside diameter. All bends are formed by an automatic
mandrel bending process. All bars maintain a constant 1 1/2" offset.
Finish: Standard finish is a #4 satin finish. For a non-slip finish (peened)
add suffix X to model number. (Ex. UG2X-B)
Flanges: Snap flanges are fabricated of 3" diameter, 3/8" deep drawn
#22 ga stainless steel with #4 satin finish to match tubing. Flanges have
dimples that secure over mounting plate.
Strength: Bars with a 1 1/2" offset clearance will support loads in excess
of 900lbs when property installed. Bars with greater offsets will support
loads up to 250lbs when property installed.
Installation: Before installing grab bars, verify with all state and local
codes for requirements on bar diameter and type finish. Recommended
mounting heights for grab bars are 33" - 36" centerline above finished floor.
All mounting of grab bars when poss ble should have in wall mounting
back plates. Find centerline mounting points and place bar on line making
sure to be on center. Transfer mounting points (3 per flange) to wall. Drill
pilot holes and secure bar with proper anchors per application. Snap cover
over mounting plate.
Standard Lengths (Other sizes available upon request): 60" 72"